Jeep Brake Booster
As the name implies, the Jeep brake booster is a device which helps the driver
in achieving superior braking capabilities. It is a mechanical component which
uses a pressure source to lessen the effort being exerted by the driver in stopping
the vehicle. This is done by increasing the effort directed to the brake master
cylinder.
The Jeep brake booster is an important in your vehicle if you want to make sure
that your Jeep brake system is highly-reliable. The brake booster is important
as it makes easy for the driver to apply brake. This should be installed in your
vehicle for your safety assurance, driving comfort, and confidence to hit high
speed levels without worrying about braking failure.
To install it in your vehicle, be sure that the pedal support bracket is aligned
before placing the brake booster in position on the dash panel, after which hand-start
the retaining nuts. When working inside your vehicle, it is necessary to install
the master cylinder pushrod spacer or speed control dump valve. The head of the
bushing should be on the side of the push rod, away from the pedal arm. It is
also necessary to position the speed control dump valve to the dash panel and
make sure to secure it with two screws. Move the wiring harness into position,
and then install the shift cable and bracket. After that, connect the manifold
vacuum hose to the brake booster check valve. At this point, you can already engage
the fluid level warning indicator. Then connect the negative battery cable to
make engine start and allow you to see whether the brakes function.
It is true that Jeep brake boosters can really gives you more assurance of strong
and reliable braking. However, that doesn’t assure ultimate safe ride. Thus regular
inspection is still very much necessary. You can check whether your Jeep brake
booster is functioning or not by turning off the vehicle, pressing on the pedal
and restarting your vehicle. If the pedal sinks an inch or more, then the power
assist is operating well.
